Esp8266 Pv19 Modbus Register 25261: Inverter Error message 1

Technical Definition

The register Inverter Error message 1 at address 25261 is used to monitor inverter error message 1 on the Esp8266 Pv19.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Inverter Error message 1 (Address: 25261)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=25261, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Inverter Error message 1"
  address: 25261
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp8266 Pv19]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Provides a textual error code or message from the inverter regarding its operational status. Units are typically ASCII or numerical codes.

Troubleshooting: A non-zero or specific error code indicates an inverter malfunction. Refer to the inverter manual for specific code meanings and resolution.