Esp32 S3 Zero Deye8K Modbus Register 663: Gen Port Voltage L3

Technical Definition

The register Gen Port Voltage L3 at address 663 is used to monitor gen port voltage l3 on the Esp32 S3 Zero Deye8K.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Gen Port Voltage L3 (Address: 663)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=663, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Gen Port Voltage L3"
  address: 663
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 S3 Zero  Deye8K]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Voltage on phase L3 of the generator port. Units: Volts (V).

Troubleshooting: Check L3 wiring, generator output, and phase balance. Possible sensor fault.