Esp32 S3 Zero Deye8K Modbus Register 661: Gen Port Voltage L1

Technical Definition

The register Gen Port Voltage L1 at address 661 is used to monitor gen port voltage l1 on the Esp32 S3 Zero Deye8K.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Gen Port Voltage L1 (Address: 661)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=661, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Gen Port Voltage L1"
  address: 661
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 S3 Zero  Deye8K]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Generator port voltage on Line 1 (V). Voltage from a generator source connected to the inverter.

Troubleshooting: Zero if generator not active or connected. Check generator status, wiring, and connection.