Esp32 S3 Zero Deye8K Modbus Register 557: Error2

Technical Definition

The register Error2 at address 557 is used to monitor error2 on the Esp32 S3 Zero Deye8K.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Error2 (Address: 557)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=557, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Error2"
  address: 557
  value_type: U_WORD
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 S3 Zero  Deye8K]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Indicates the second level of critical error or fault condition detected by the system.

Troubleshooting: Non-zero value requires consulting the device manual for specific error code interpretation and immediate action.