Esp32 Phnix Heroplus Heat Pump Modbus Register 2013: Temperature value after limiting

Technical Definition

The register Temperature value after limiting at address 2013 is used to monitor Temperature value after limiting on the Esp32 Phnix Heroplus Heat Pump.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Temperature value after limiting (Address: 2013)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=2013, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Temperature value after limiting"
  address: 2013
  value_type: S_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 Phnix Heroplus Heat Pump]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: The calculated or measured Temperature after internal system adjustments for heating. Units: Degrees Celsius (°C) or Fahrenheit (°F).

Troubleshooting: Unusually low/high values suggest sensor issues or incorrect control logic. Verify system performance.