Esp32 Jk Pb Modbus Example Modbus Register 4204: Name cell count

Technical Definition

The register name cell count at address 4204 is used to monitor name cell count on the Esp32 Jk Pb Modbus Example.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name cell count (Address: 4204)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4204, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name cell count"
  address: 4204
  value_type: U_DWORD
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 Jk Pb Modbus Example]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Number of cells connected in series within the battery pack. Unitless integer. Essential for voltage calculations and balancing.

Troubleshooting: Zero value indicates no cells detected. Check cell connections, wiring integrity, and the battery management system's ability to read cells.