Esp32 Example Modbus Register 20: Name cell voltage 6

Technical Definition

The register name cell voltage 6 at address 20 is used to monitor name cell voltage 6 on the Esp32 Example.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name cell voltage 6 (Address: 20)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=20, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name cell voltage 6"
  address: 20
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 Example]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Voltage of cell 6 in a battery pack. Units: Volts (V). Indicates individual cell health.

Troubleshooting: 0V: Open circuit in cell, faulty connection, or internal cell failure. Check wiring and cell integrity.