Esp32 Example Advanced Multiple Uarts Modbus Register 220: Device0 pv average current

Technical Definition

The register device0 pv average current at address 220 is used to monitor device0 pv average current on the Esp32 Example Advanced Multiple Uarts.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read device0 pv average current (Address: 220)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=220, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "device0 pv average current"
  address: 220
  value_type: S_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esp32 Example Advanced Multiple Uarts]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Average PV current for Device 0, measured in Amperes (A).

Troubleshooting: Check solar panel output, wiring integrity, and sensor functionality if current is zero or unexpected.