Epever Upower Modbus Register 38407: Charging Mode

Technical Definition

The register Charging Mode at address 38407 is used to monitor charging mode on the Epever Upower.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Charging Mode (Address: 38407)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=38407, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Charging Mode"
  address: 38407
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Epever Upower]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Control mode for battery charging. Values represent different charging algorithms (e.g., PWM, MPPT).

Troubleshooting: Zero or invalid value indicates configuration error or communication issue. Consult manual for valid modes.