Epever Scc Entities Sensor Modbus Register 36869: Scc name Overvoltage Reconnect Voltage

Technical Definition

The register scc name Overvoltage Reconnect Voltage at address 36869 is used to monitor scc name overvoltage reconnect voltage on the Epever Scc Entities Sensor.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read scc_name Overvoltage Reconnect Voltage (Address: 36869)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=36869, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "scc_name Overvoltage Reconnect Voltage"
  address: 36869
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Epever Scc Entities Sensor]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Voltage threshold (V) at which the SCC reconnects charging after a previous overvoltage disconnect.

Troubleshooting: If the battery voltage never drops below this, charging may remain disconnected. Check battery state and load.