Epever Scc Entities Sensor Modbus Register 13068: Scc name PV Generated Energy Day

Technical Definition

The register scc name PV Generated Energy Day at address 13068 is used to monitor scc name pv generated energy day on the Epever Scc Entities Sensor.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read scc_name PV Generated Energy Day (Address: 13068)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=13068, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "scc_name PV Generated Energy Day"
  address: 13068
  value_type: U_DWORD_R
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Epever Scc Entities Sensor]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Energy generated by PV today. Measured in Kilowatt-hours (kWh). Total solar energy produced within the current day.

Troubleshooting: Zero may indicate no solar production today, or a fault/reset of the energy counter. Check PV input parameters.