Epever Mppt Controller Full Modbus Register 12290: MPPT SPEC: PV Rated Power

Technical Definition

The register MPPT SPEC: PV Rated Power at address 12290 is used to monitor mppt spec: pv rated power on the Epever Mppt Controller Full.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read MPPT SPEC: PV Rated Power (Address: 12290)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=12290, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "MPPT SPEC: PV Rated Power"
  address: 12290
  value_type: U_DWORD_R
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Epever Mppt Controller Full]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: The nominal power output of the Photovoltaic (PV) array. Units: Watts (W).

Troubleshooting: Zero implies no PV power generation, possibly due to zero current/voltage, severe underperformance, or controller fault.