Epever Inverter Entities Sensor Modbus Register 12554: Inverter name Load Input Power

Technical Definition

The register inverter name Load Input Power at address 12554 is used to monitor inverter name load input power on the Epever Inverter Entities Sensor.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read inverter_name Load Input Power (Address: 12554)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=12554, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "inverter_name Load Input Power"
  address: 12554
  value_type: U_DWORD_R
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Epever Inverter Entities Sensor]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Load input power consumed by the inverter. Unit: Watts (W).

Troubleshooting: Zero power indicates no load. Significant deviation from expected may signal issues with connected devices or power source.