Easun Modbus Register 100: Name fault code

Technical Definition

The register name fault code at address 100 is used to monitor name fault code on the Easun.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name fault code (Address: 100)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=100, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name fault code"
  address: 100
  value_type: U_DWORD
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Easun]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Indicates a specific fault condition within the Easun device. '0' usually means no fault is present.

Troubleshooting: Non-zero values indicate specific errors. Consult the Easun manual for fault code meanings and resolution.