Dixell Ic100Cx Interface Modbus Register 258: Current underfloor in Temperature

Technical Definition

The register Current underfloor in Temperature at address 258 is used to monitor current underfloor in Temperature on the Dixell Ic100Cx Interface.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Current underfloor in temperature (Address: 258)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=258, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Current underfloor in temperature"
  address: 258
  value_type: INT16
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Dixell Ic100Cx Interface]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Measures the current Temperature at the inlet point of the underfloor heating system. Units are degrees Celsius (°C) or Fahrenheit (°F).

Troubleshooting: Zero could indicate a sensor failure or a very cold condition. Check sensor wiring, calibration, and ambient Temperature.