Deye Seplosv3 Modbus Register 618: Device type-External CT L3 Power

Technical Definition

The register device type-External CT L3 Power at address 618 is used to monitor device type-external ct l3 power on the Deye Seplosv3.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read device_type-External CT L3 Power (Address: 618)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=618, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "device_type-External CT L3 Power"
  address: 618
  value_type: S_WORD
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Seplosv3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Phase L3 power reading from external Current Transformer (CT). Units: Watts (W).

Troubleshooting: Check L3 CT connection, wiring integrity, and ensure L3 load is active. Verify device configuration.