Deye Seplosv3 Modbus Register 527: Device type-Total Consumption

Technical Definition

The register device type-Total Consumption at address 527 is used to monitor device type-total consumption on the Deye Seplosv3.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read device_type-Total Consumption (Address: 527)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=527, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "device_type-Total Consumption"
  address: 527
  value_type: U_DWORD_R
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Seplosv3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total energy consumed by the load from all sources (kWh).

Troubleshooting: Zero if no load has consumed power or if the meter is faulty.