Deye Seplosv3 Modbus Register 4377: Bms name mosfet Temperature

Technical Definition

The register bms name mosfet Temperature at address 4377 is used to monitor bms name mosfet Temperature on the Deye Seplosv3.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read bms_name mosfet temperature (Address: 4377)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4377, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "bms_name mosfet temperature"
  address: 4377
  value_type: S_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Seplosv3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: MOSFET Temperature in °C. Monitors the operating Temperature of power switching components.

Troubleshooting: 0 value suggests a sensor failure, overheating protection trigger, or a BMS data error.