Deye Inverter Entities Sensor Modbus Register 84: Name inverter name load energy today

Technical Definition

The register name inverter name load energy today at address 84 is used to monitor name inverter name load energy today on the Deye Inverter Entities Sensor.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name inverter_name load energy today (Address: 84)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=84, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name inverter_name load energy today"
  address: 84
  value_type: U_WORD
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Inverter Entities Sensor]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total energy consumed by the load today (kWh). Measures power drawn by connected appliances.

Troubleshooting: Zero value suggests no load connected or active today, or a sensor/communication fault. Verify connected loads and sensor readings.