Deye Inverter Entities Sensor Modbus Register 210: Name inverter name battery max charge current

Technical Definition

The register name inverter name battery max charge current at address 210 is used to monitor name inverter name battery max charge current on the Deye Inverter Entities Sensor.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name inverter_name battery max charge current (Address: 210)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=210, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name inverter_name battery max charge current"
  address: 210
  value_type: U_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Inverter Entities Sensor]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Maximum current (Amps) the battery can accept during charging. Crucial for battery health and charging speed.

Troubleshooting: Zero indicates charging disabled or a critical battery fault. Check inverter settings and battery BMS for issues.