Deye Inverter Entities Advanced Modbus Register 13: Name inverter name firmware control board

Technical Definition

The register name inverter name firmware control board at address 13 is used to monitor name inverter name firmware control board on the Deye Inverter Entities Advanced.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name inverter_name firmware control board (Address: 13)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=13, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name inverter_name firmware control board"
  address: 13
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Inverter Entities Advanced]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Firmware version of the inverter's control board. Identifies the software running the main operations.

Troubleshooting: Zero or invalid value could mean a boot failure, corrupted firmware, or hardware issue with the control board.