Dev S3 Eb3 Modbus Register 119: Dev Active Power L3

Technical Definition

The register dev Active Power L3 at address 119 is used to monitor dev active power l3 on the Dev S3 Eb3.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read dev Active Power L3 (Address: 119)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=119, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "dev Active Power L3"
  address: 119
  value_type: U_DWORD
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Dev S3 Eb3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Active power consumed or generated by Phase L3. Units: Watts (W).

Troubleshooting: Check L3 voltage and current, connection integrity, and device health. Possible overload or sensor fault.