Ctc Ecozenith I250 Modbus Register 559: Heating circuit 1: Primary flow setpoint Temperature

Technical Definition

The register Heating circuit 1: Primary flow setpoint Temperature at address 559 is used to monitor heating circuit 1: primary flow setpoint Temperature on the Ctc Ecozenith I250.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Heating circuit 1: Primary flow setpoint temperature (Address: 559)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=559, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Heating circuit 1: Primary flow setpoint temperature"
  address: 559
  value_type: S_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Ctc Ecozenith I250]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Target Temperature for the primary heating circuit flow (°C). Sets the desired water Temperature delivered to the heating system.

Troubleshooting: Zero indicates a potential control system issue or no heating requirement. Verify control logic and system demand.