Bms Combine Modbus Client Modbus Register 27: Balance trigger voltage

Technical Definition

The register balance trigger voltage at address 27 is used to monitor balance trigger voltage on the Bms Combine Modbus Client.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read balance trigger voltage (Address: 27)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=27, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "balance trigger voltage"
  address: 27
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Bms Combine Modbus Client]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: The voltage level at which cell balancing is initiated. Ensures even charge distribution across cells. Units are Volts (V).

Troubleshooting: A 0 value suggests balancing is disabled, unconfigured, or a fault prevents the BMS from determining the correct trigger voltage.