Baxi esp Modbus Register 409: AM019 Presion de Agua

Technical Definition

The register AM019 Presion de Agua at address 409 is used to monitor am019 presion de agua on the baxi esp.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: bar
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read AM019 Presion de Agua (Address: 409)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=409, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "AM019 Presion de Agua"
  address: 409
  value_type: U_WORD
  unit_of_measurement: "bar"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[baxi_esp]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: AM019 Water Pressure. Likely in Bar or kPa. Measures the static or dynamic pressure of the water system.

Troubleshooting: Zero value indicates no water flow or pressure loss. Error suggests a pressure sensor failure or a significant system leak.