Batt Monitoring Modbus Register 2: Battery2 A

Technical Definition

The register Battery2 A at address 2 is used to monitor battery2 a on the Batt Monitoring.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Battery2_A (Address: 2)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=2, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Battery2_A"
  address: 2
  value_type: S_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Batt Monitoring]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Battery 2 current, measured in Amperes (A). Represents the flow of electrical charge in or out of the battery.

Troubleshooting: Zero may indicate no charge/discharge. Negative values typically mean discharging, positive charging. An unexpected value might signal a sensor fault or abnormal load.