Bat Modbus Register 12294: Battery rated power

Technical Definition

The register battery rated power at address 12294 is used to monitor battery rated power on the Bat.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read battery_rated_power (Address: 12294)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=12294, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "battery_rated_power"
  address: 12294
  value_type: U_DWORD_R
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Bat]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Nominal power rating of the battery pack, usually in Watts (W). Calculated from rated voltage and current.

Troubleshooting: A 0 value could be a calculation error or indicate battery inactivity. An incorrect value points to issues with voltage/current sensors or the BMS.