Bat Modbus Register 12293: Battery rated current

Technical Definition

The register battery rated current at address 12293 is used to monitor battery rated current on the Bat.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read battery_rated_current (Address: 12293)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=12293, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "battery_rated_current"
  address: 12293
  value_type: U_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Bat]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Nominal current rating of the battery pack, usually in Amperes (A). Specifies maximum continuous charge/discharge current.

Troubleshooting: A value of 0 might imply the battery is not configured for current flow or a BMS issue. An incorrect reading suggests a sensor or communication fault.