Atom S3 Lite Rs485 Modbus Register 33010: Monthly Discharging Energy

Technical Definition

The register Monthly Discharging Energy at address 33010 is used to monitor monthly discharging energy on the Atom S3 Lite Rs485.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Monthly Discharging Energy (Address: 33010)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=33010, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Monthly Discharging Energy"
  address: 33010
  value_type: U_DWORD
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Atom S3 Lite Rs485]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Energy discharged from the battery monthly (kWh). Tracks the total monthly energy drawn from the battery.

Troubleshooting: Zero may indicate no discharge this month, a system reset, or a data logging error. Check monthly load conditions.