Ashp Modbus Register 4: Heat Pump Fan Control RPM

Technical Definition

The register Heat Pump Fan Control RPM at address 4 is used to monitor heat pump fan control rpm on the Ashp.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: rpm
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Heat Pump Fan Control RPM (Address: 4)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Heat Pump Fan Control RPM"
  address: 4
  value_type: U_WORD
  unit_of_measurement: "rpm"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Ashp]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Fan speed in Revolutions Per Minute (RPM). Controls airflow for heat exchange efficiency.

Troubleshooting: Zero implies fan failure, motor issue, or control signal loss. Erratic values suggest sensor or motor problems.